Protective agent ( joints and tiles ).

  • Colourless: Preserves the natural appearance of the surfaces.
  • Protects surfaces from incrustation and the effects of pollution.
  • Simple application
  • couverture

    Covers: 5 m²/ L

  • contenu

    Contain: Bucket 20L & Cans 1L and 5L

  • sol

    Floor: interior/exterior | Wall: interior/exterior

  • pret-a-lemploi

    Ready to use

MEP®. JOINT Protect is a colourless water repellent made of silanes and siloxanes. It is used for the colourless protection of tile joints and natural stone. It can also be used for the protection of concrete facades, cement plaster, and front facing bricks.

USES

MEP®. JOINT Protect is recommended for :

  • • Protecting tile joints.
  • • The protection of natural stone surfaces and bricks.
  • • The protection of facades against rainfall.
  • • The preventive treatment against carbonation of the concrete.
  • • It also minimizes unsightly formation of efflorescence on the walls.
PERMITTED SUPPORTS
  • • Mortars and concrete
  • • Natural stones
  • • Bricks, clay or concrete tiles
  • • Mineral coatings based on lime or cement
  • • Protective agent for joints, tiles and natural stone.
  • • Colourless: Preserves the natural appearance of the surfaces.
  • • Protects surfaces from incrustation and the effects of pollution.
  • • Simple application.
SAFETY DATA SHEET REQUEST      DOWNLOAD PRODUCT SPECIFICATIONS
  1. Surface Preparation :

    The surfaces to be treated must be perfectly clean: Eliminate any substance that may prevent the product from penetrating deeply (dust, formwork oil, efflorescence, moss, grass, various types of dirt, etc.).
    As a general rule, a high-pressure wash is sufficient.
    Whichever cleaning system is chosen, MEP®. JOINT Protect can only be applied on a perfectly dry and porous surface.

  2. Preparing the product :

    MEP®. JOINT Protect is ready to use and must be used without dilution or addition.

  3. Product Application :

    The effectiveness of the product depends on the depth of penetration into the surface. This parameter is naturally a function of the porosity of the material to be treated and the quantity of product applied.
    For a homogeneous distribution, it is advisable to apply MEP®. JOINT Protect, with a sprayer in the case of large surfaces (possibly with a brush or roller).
    For smaller surfaces or tile joints, use a brush.
    In all cases, MEP®. JOINT Protect is applied to saturation, in two or even three successive passes if necessary.

  4. RECOMMENDATIONS :

    • Protect surfaces that are not to be treated: glass (windows).
    • Protect plants against accidental projections.
    • Clean tools with white spirit