MEP®.COL Primo
Commonly used adhesive mortar. (C1)
SEE MOREFloor: Interior
View video
MEP®. EFFET Béton ciré is a fine decorative coating intended for the decoration of private homes.
MEP®. EFFET Béton ciré is a fine-grained mortar allowing the nuanced finish of a waxed concrete effect indoors.
On new flooring
On concrete and cement mortar screed.
On cement-based self-leveling floor plaster.
On low temperature heated floor.
In renovation
On old adherent tiles *
On old adherent and resistant paints *
* Subject to preparation, with reinforced intermediate layer and with bonding primer.
SAFETY DATA SHEET REQUEST DOWNLOAD PRODUCT SPECIFICATIONS• Remove all traces of grease, oil, and cement laitance.
• Dust off.
• Caution: the residual humidity of the floor should not exceed 5%.
• In the event of holes or significant flatness defects, fill with MEP®. REP Sol.
• MEP®. PRIM GP is ready to use and must not be diluted.
• It is applied with a roller, brush or rubber sponge, taking care to distribute the product evenly on the substrate at a rate of 150 to 250 g/m².
• Do not leave over dosage or shortages.
• Drying time: 1 to 4 hours depending on the type of surface, temperature and relative humidity.
Application No 1 - Coarse coat
• Mix with 5 to 6 litres of DURA®. LATEX per 20 kg bag until a soft and homogeneous mortar is obtained.
• Add the colorant dose and stir to homogenize the colour.
• The paste obtained must be left to rest for 5 minutes and then stir again before use.
• Spread the "coarse coat" mortar with the stainless steel smoothing machine, with a wide movement, in cross passes.
• Take care to maintain a thin layer sufficient to easily allow evacuation of air bubbles.
• Allow to dry for 4 to 24 hours before applying the second coat.
• Stir with 7 to 8 litres of water per 20 kg bag until a soft and homogeneous mortar is obtained.
• Add the colouring dose and stir to homogenize the colour.
• The paste obtained must be left to rest for 5 minutes and then stir again before use.
• Spread the "Fine coat" mortar with a stainless steel smoothing tool by ironing the product.
• Allow to dry for 4 to 24 hours before applying the second coat.
- MEP®. PRIM BP is ready to use and must not be diluted.
- It is applied with a varnish roller, taking care to distribute the product evenly on the surface at a rate of 150 g/m².
- Drying time: 15 min to 2 hrs depending on the nature of the surface, temperature and relative humidity.
Do not apply:
• Outdoors
• On cracked or unstable ground
• On wooden floor
• On a plaster base
• On floors subject to rising dampness
• In premises with heavy traffic
• Use a suitable protective varnish: scratch and puncture resistant.
• Application temperature between 5° C and 35° C.
• Observe expansion and splitting joints.
• Do not add water to the setting mixture.
• Do not use a mixture that has started to set.
• Shelf life: 6 months from the date of manufacture, in original unopened packaging, stored in a dry place.
• Tools: Slow electric mixer, trowel, stainless steel reading light, lacquer roller.