MEP®.COL Primo
Commonly used adhesive mortar. (C1)
SEE MORECovers: 200 g / m²
Contain: Bucket 5kg & 20kg
Floor: inside/outside | Wall: inside/outside
Ready to use
See video
MEP®. PRIM PLUS is a synthetic resin-based primer enriched with silica-quartz sand that optimize and guarantees a rough keying surface specially for non-porous surface.
MEP®. PRIM PLUS is designed for priming non-porous surfaces prior to the application of:
▪ Ensure that the surfaces are not subjected to rising damp
▪ Remove any friable residues (peeling paint, old adhesive for vinyl tiles, laitance, etc)
▪ The surface must be clean and free of dust, release agent, fungi
Notes: New floors and walls must be allowed to cure for minimum periods to ensure that movement due to shrinkage does not affect the screed
▪ MEP®. PRIM PLUS is ready to use and don’t need addition of water
▪ Apply directly to the surface, using a brush or a roller
▪ Complete coverage of all surfaces is essential – at a rate of 200 to 300 g/m2
▪ Do not leave overdose or lack
▪ Drying takes between 1 to 4 hours at +20°C
▪ MEP®. PRIM PLUS must be touch dry before recoating
(1) In case of a second coat application, wait for the product to set until touch dry
(2) The interval for covering with mortar cannot exceed 24 hours. If necessary, apply an additional coat
▪ Do not use in wet area
▪ Do not use on surfaces subject to rising damp
▪ Not suitable for heavy duty traffic – use MEP®. PRIM EPOXY
▪ Do not apply in full sunlight
▪ Clean the tools with water, before drying the product
▪ The room temperature will be between +5ºC and +35ºC
▪ Packaging: 5kg and 20Kg plastic bucket
▪ Handling and storage: 6 months if kept in a dry cool place in the original packaging
In more extreme conditions this period might be shortened
▪ Tools: Paint Brush, Roller